Getting My h4831sc load data To Work
Getting My h4831sc load data To Work
Blog Article
H1000 is on my desire list of powders as well. Perhaps the IMR Enduron sequence might be perfectly favored and I'm able to transfer to that for far better availability.
Obviously, the Hodgdon tech would not endorse my mixing of different good deal figures, but I feel I realize why. It is a litigation-pushed world, and some idiot would surely deduce that he could mix H380 and H110 and come up with his possess personalized combination of powder. What a earth.
The point that the H4831 is in fact a slower burning powder is exactly why you are observing larger velocities attained with that powder, versus Whatever you've seen With all the IMR things. Also very good powder, but rather greater suited to somewhat lesser scenarios with a bit considerably less capacity.
Sweet!! I will select some up and give it a try. Thanks men, I enjoy it! I'll Allow you to really know what I learn. I do have about a 50 % pound of 4350 I'm able to attempt that first and see what happens.
Thornton, CO Source of H4831SC is beginning to dwindle down too so get what you'll need on your new load I would advise. May very well be all of almost nothing whenever they restock all the things Soon but Those people powders are owning transportation regulation challenges.
WARNING: This product can expose you to steer, which is thought for the State of California to trigger most cancers and delivery defects or other reproductive damage. To learn more head to – .
If there isn't any load data it really is because this powder isn't ideal for this cartridge. Generally a single h4831 vs h4831sc is not going to locate a single powder to fit all cartridges, and the family of cartridges with The actual powder (4831SC) that you will be inquiring about would not do the job.
While this is probably legitimate, there is a good deal a lot more to it than just not blowing you up. He couldn't strike prairie puppies past about 150 yards, so I am guessing that inconsistent combustion wasn't doing just about anything favorable for his grouping skill with People loads.
The primary reason I switched from IMR 4831 to H4831 was to make use of the temperature insensitivity of the Hodgdon extreme powder.
Liberalism; The extremely hard however approved notion that it is solely probable to choose up a turd via the thoroughly clean close.
So glad your having a lot more varieties of powder back again in. Now you have to get primers back again in inventory and reloaded can commence reloading again.. just declaring
It's been a little bit, but I did get some 4831 SC to test. Found a node and shot some groups. I shot a .6 five shot group right now. It is really a bit slower than H1000, but shoots very good. Many thanks for the recommendation, it's excellent to are aware h4831sc that I have bought choices when a single or the opposite powder is dried up.
You might possibly: 1) Go on and also have the products mentioned under immediately faraway from your buying cart:
I sawed a single in half to check out how thick the jackets ended up, and so they were conveniently two times as thick as being a fifty-grain hollow level was. Ditto for the sixty four-grain Electrical power Point, as these bullets are designed for deer, not prairie puppies or woodchucks. You now know every thing I understand about the 22-250 and slow-burning powders, and I do not know something in the slightest degree with regards to the 223. I doubt that you're h4831sc load data going to get any where with that cartridge and 4831, but allow us to know the way it goes.